Filling Your CE5 Clearomizer
Unscrewing: Grip the CE5 clearomizer and unscrew the mouthpiece (drip tip) from the top of the tank.
Filling: Tilt the clearomizer slightly. Carefully pour your e-liquid down the inside wall of the tank, avoiding the central airflow tube. Do not overfill; observe any maximum fill line if present, or fill to approximately 80% capacity to prevent leaking and ensure proper function.
Reassembling: Screw the mouthpiece firmly back onto the clearomizer. Ensure it is snug to prevent leaks, but do not overtighten.
Preparing and Using Your CE5
- Priming the Coil: If using a new clearomizer or after replacing the atomizer head, let the filled CE5 stand upright for 5-10 minutes. This allows the e-liquid to fully saturate the wick, which helps prevent dry hits and prolongs the life of the coil.
- Attaching to Battery: Screw the filled CE5 clearomizer onto your compatible battery (typically an eGo-style battery). Ensure a secure connection, but do not overtighten as this can damage the threads.
- Turning On/Off: Most batteries used with CE5 clearomizers are turned on or off by pressing the power button rapidly 5 times within 2 seconds. The button light will usually flash to confirm the device is on or off.
- Vaping: Press and hold the power button while gently inhaling from the mouthpiece. Release the button when you have finished your puff. Do not hold the button down if you are not actively inhaling, as this can burn the coil.
Charging and Maintenance
Charging: When the battery power is low (often indicated by a flashing button during use or reduced vapor production), unscrew the CE5 clearomizer from the battery. Screw the battery into the USB charger specifically designed for it. Plug the USB charger into a suitable power source (e.g., computer USB port or a compatible wall adapter). The charger’s indicator light will typically show the charging status (e.g., red while charging, green when fully charged).
Atomizer Head Replacement: The CE5 clearomizer contains an atomizer head (coil) which is a consumable part. It will need replacing when you notice a significant decrease in vapor production, a burnt taste, or leaking. To replace it:
- Unscrew the base of the CE5 clearomizer from the tank section.
- Unscrew the old atomizer head from the base.
- Screw a new, compatible atomizer head onto the base.
- Reassemble the clearomizer, refill if necessary, and prime the new coil as described above.
Cleaning: Periodically, you can clean the tank section of your CE5 clearomizer. Disassemble it (remove mouthpiece and base). Rinse the tank and mouthpiece with warm water. Allow all parts to dry completely before reassembling and refilling. Avoid getting the battery or atomizer head wet if not designed for it.
